64-68 Mustang Carburetor Spacer Kit, Deluxe, 6 Cylinder,
(Before 1/15/68)

$72.99

The only 6 cylinder carburetor spacer kit available on the market today! Kit includes PCV plug, PCV fitting, carburetor to spacer gasket and spacer to intake manifold gasket. We also added four flat washers that Ford never used in the kit, but in retrospect they probably would have used them. Two washers are placed on the mounting bolts to protect the finish of the carburetor spacer and the other two washers are placed on the mounting studs after the carburetor has been placed on the spacer then the nuts are attached. This protects the carburetor from torque gouges from the nuts when being tightened. It gives a very nice overall appearance. See photo below for example.

Notes: The PCV plug is used on cars with open emissions. Cars with closed emissions use the PCV fitting. You will need to reuse your bolts that connect the carburetor spacer to your intake manifold. The animated photos below shows bolts for reference so you know where the other two washers are to be used.

Fits:
64-65 Mustang with 170, 200 engines.
66-67 Mustang with 200 engine w/ TE & C4.
68 Mustang with 200 engine before 1/15/68.

Shown Installed


Fits the following year models:
1964
1965
1966
1967
1968

Add to Cart:

  • Part Number: CAG-1100-KIT
  • Supplied by: Champion Auto Group


This product was added to our catalog on Monday 15 November, 2010.

Disclaimer: Champion Mustang is not affiliated with Ford Motor Company. All products containing or displaying the Ford brand are licensed by Ford through their respective manufacturer. All products herein are reproductions and not directly or indirectly affiliated with Ford unless noted. Champion Mustang is a division of Champion Auto Group and operates as an extension of Champion Auto Group.

Your IP Address is: 100.26.182.28